1. Elbow/Bend

Horizontal elbow 45 & 90 degrees deigned to change the direction of the cable tray at an angle. and vertical elbow deigned to change the cable tray from one horizontal level to another horizontal level.

1. Tee connection

Designed to collect three cable trays in three directions between each cable tray 90 degree angle in the same horizontal plane.

1. Reducer

Designed to change the width of the cable tray.

1. Cross section

Designed to collect four cable trays in four directions between each cable tray 90 degree angle in the same horizontal plane.

1. Riser bend

Internal riser designed to change the direction of the cable tray from the lowest level to the highest level.

External riser designed to change the direction of the cable tray from the highest level to lowest level.

1. Connectors / splice plates / couplers

Connectors Design to connect two cable tray together;

• Straight connector

• Angle connector

• Vertical Adjustable connector

• Horizontal adjustable connector

1. Cable tray Covers

Designed to cover the cable trays to protect the cables inside.

1. Fish Plate

Designed to fix the strong between the two connections of the cable trays in additional to the connectors and also to protect the cables placed on the cable tray from any sharp edges.

1. End Plate

Designed to use the end of the cable tray to lock it

10-Dividers/ Barrier strips

Designed as a barrier to separate two sets if cables of different types within the same cable tray ( such as ordinary cables, emergency cables , or cables of different voltage levels )

11- Flexible expansion coupler

Designed to connect two cable trays at the structural expansion joints of the building also at the places where vibrations of the cable tray are likely to occur.

12- Drop-out plate

Designed for the cables to descend from the ladder tray type, whether the cables are descended in between any two cross bars of the tray (and in this case are fixed on one of the cross bars ) or from the side of the tray ( and are installed on the tray side )

13- Tray to box splice plate

Designed to fix the end of the cable tray to the electrical distribution board or the control panel.

14- Offset Reducing Connector

Designed to combine two cable trays of different widths

15- Junction Box plate

Designed to fix the junction box on the side of the tray

15- Washer and Nut

16- Threaded Rod

17- Support Brackets